I was on the road for much of the last two weeks, so I didn't make a lot of progress. I did measure the width of my garage and discovered that I have more than enough room to temporarily attach the wings. I had forgotten how much shorter the wings are when the fibreglas wingtips aren't attached. I had expected that I would have to fit the wings after moving the aircraft to a hangar.

So, this weekend I fabricated, riveted and primed the various aileron pushrods. I've got a few more odds and ends to do, then I'll fit the wings, adjust the aileron and flap pushrods, fabricate the fuel lines from tank to fuselage, fit the intersection fairings between wing and fuselage, etc. I'll start the engine installation after I remove the wings.